SUN MPIO DSM WINDOWS 8 X64 DRIVER DOWNLOAD

SUN MPIO DSM DRIVER DETAILS:

Type: Driver
File Name: sun_mpio_33033.zip
File Size: 30.0 MB
Rating:
4.63
136 (4.63)
Downloads: 88
Supported systems: ALL Windows 32x/64x
Price: Free* (*Free Registration Required)

Download Now
SUN MPIO DSM DRIVER



The portion of a volume that is located on a single Member is referred to as a volume slice. Follow Us.

Privacy Terms. Specifies whether MPIO performs custom path recovery. More information about text formats. Text format Comments Plain text.

SUN MPIO DSM DRIVERS WINDOWS XP

If you want to access the JBod with two Clusternodes, you don't have a Multipath configuration. You have two JBods in one case each attached with one path to each clusternode. This is literally as simple a setup as it gets, single switch, flow control and jumbo enabled on the switch and the NICs. I'm not remoted in right now but from sun mpio dsm there are a couple of errors where both MPIO sun mpio dsm fail at the time that the volume goes offline. Support for multiple connections to a single iSCSI target volume.

Configuring Multipath-IO for Windows Server /R2/ - Pure1 Support Portal

As a result, multiple DSMs can be installed on a single host, each one potentially managing different storage arrays. To avoid conflicts, make sure that only one copy of a failover driver is installed and sun mpio dsm.

The following naming convention has been established for the DSM driver:. Driver names must follow an 8. This is a restriction of the operating sun mpio dsm itself. It is important that the timeout value for the requests from the DSM driver be at least as large as sun mpio dsm timeout value for the MS Disk driver.

As a result, the rule above was modified as follows:. If neither value is defined, the value defaults to 10 seconds.

atheros 928xTo Enable Multipathing in Windows Server 2008
ep 8kda7i13 Replies
pixela imagemixer for sonyPopular Tags
finepix a510Enabling and Disabling Multipathing in the Windows Operating System

For example, if the SynchTimeout is seconds and the TimeOutValue is 60 seconds, use seconds for the sun mpio dsm. The following storage arrays are supported by the DSM driver. For a failover driver to claim ownership over the default Disk.

Installation of the failover drivers takes very little time sun mpio dsm to the required modifications to the device nodes in the Registry. A list of all the disk drives by manufacturer ID and type are displayed.

Sun Hardware - Disk Storage Patches

At this point, MPIO is installed and configured for dual paths. A, B, and C are listed as primary paths and D is standby path.

The second path is hidden by Windows. By default, MPIO is configured for active passive path failover. Error trying to allocate data structures. Error trying to create virtual target. Error trying to determine controller slot. Error trying to insert a new volume. Error trying to insert a new volume path. Failover command sun mpio dsm. Failover failed, no path to volume. Hardware error.

DiskStation Manager - Knowledge Base Synology Inc.

Incorrect close type for virtual bus node. Incorrect open type for virtual bus node. Inquiry wait time exceeded. Maximum number of storage arrays exceeded. Spiceworks Sun mpio dsm Desk. The help desk software for IT.

HP : 1 Visit www. Research Report: IT Priorities.The Sun StorageTek Multipath I/O (MPIO) Device Specific Module (DSM) for and Series Arrays is available for the following Windows OS versions:. Sun StorageTek MPIO DSM Installation Guide • Sun mpio dsm Windows OS explains how to install the Sun StorageTek MPIO Device Specific.

Relevant Posts