Type: Driver
File Name:
File Size: 27.6 MB
38 (4.87)
Downloads: 32
Supported systems: Windows 2008, Windows XP, Windows Vista, Windows 7/8/10
Price: Free* (*Free Registration Required)

Download Now


Jimmy, Summasign d610 are running FlexiSign Pro 7. But I still have some question I have not found answers in.

SummaSign Pro Downloads

I have an old Summa Sign D and I am absolutely not a professional user of it yet I am learning and will learn more!! I have been working with illustrator a lot so I am familiar wit that program but I need to learn more about the Summa machine I bought a couple of years ago. I re-installed Winplot when I first tried summasign d610 cut this latest logo and it went wrong. I tried to cut a logotype and something went wrong. The time now is AM. Which length dou you wish. To achieve this, press one side of the camshaft while tightening the set screws.

Remove the left-hand cover summasign d610 Chapter 2. Remove the connector from the encoder and solder off the black and the red wire to expose the Xmotor.

Remove the three screws holding the X-motor in place. Remove the X-motor. Note: When re-installing: a. Make sure the wire of the connector attached to the encoder runs outward. Be extremely careful summasign d610 plug the connector summasign d610 the correct holes of the encoder.

Move the pulley on summasign d610 motor shaft to prevent the belt from slipping against the big pulley. Make sure to firmly tighten the set-screw. Although both motors are driven, only the one with the encoder is used for feedback. Disconnect the connector. Remove the three screws holding the motor in place. Remove the motor. Remove the brown and the orange wire by soldering them off. It is extremely important that the two rotating belts do not touch.

Make sure to position each belt correctly to avoid malfunctioning. Remove the right-hand cover see Chapter 2. Remove the connector summasign d610 the encoder and solder off the black and the red wire to expose the Ymotor. Summasign d610 the three screws holding the Y-motor in place. Remove the Y-motor.


Loosen one end of the flat cable for the head by pulling the flat cable connector up. On summasign d610 sides of the connector cover there is a small protuberance that you can pry up using a screwdriver.

  • Summasign Maintenance Manual Bit Rate Computer Hardware
  • Summa SummaSign D Manuals
  • Motor for Summa Plotter
  • This week's promotions

Gently pull the flat cable out summasign d610 the connector and pull the flat cable loose it sticks to the other flat cables. Pull the flat cable for the keyboard off the PCB.

Summa SummaSign D Manuals

Remove the four screws holding the keyboard in place. Remove the keyboard. Remove the keyboard see above.


Remove the four screws holding the LCD in place. Remove the LCD. The boards on the new cutters have the logic for the head control on the summasign d610 main PCB whereas the parallel input is on an extra board.

You can obtain this option by ordering part number The new type of boards are fully compatible with the old type of boards, the only difference being the position of particular connectors, and certain parts, summasign d610 situated on the small PCB, that can now be found on the main PCB. The old type of boards can be summasign d610 for the new type of boards.Find downloads for Summa's entire product line.

leadtek winfast gt 240Our Summa of Love loyalty bonus values are:
hp laserjet cp1215 mac osItem added to cart.
hp mp2210Request a Quote
canon eos 350d cameraWelcome To Largest Forum for Signmaking Professionals

Download firmware, drivers and software for Summa vinyl cutters, flatbed systems and printer summasign d610. Find user manuals for all Summa equipment and software including Summa vinyl cutters, flatbed systems and printer cutters.

Relevant Posts